본 논문에서는 스트립라인 전송선로 구조와 공통 결함접지구조를 이용하여 초고주파 대역에서 가지선로 결합기를 소형화하여 설계하고 실제 제작한 결과에 대하여 기술한다. 마이크로스트립 선로보다 신호의 누설이 적어 전송특성이 우수한 스트립라인 전송선로 구조로 분기선로 결합기를 먼저 설계한다. 여기에 종래에 널리 알려진 전송선로용 주기구조의 일종인 결함접지구조를 두 전송선로에 동시에 적용한 공통 결함접지구조로 사용한다. 이 과정에서 공통 결함접지구조를 적용하여 제작한 결합기는 단일 결함접지구조일 때에 비하여 약 절반의 크기를 갖는다. 성능 측정 결과 각 단자에서의 정합특성은 –25dB 이하, 두 출력단자에서의 신호분배는 –3.3dB였으며, 격리단자에서의 특성은 –30dB 이하이다. 측정 결과는 회로의 크기가 거의 절반으로 줄어들었음에도 불구하고 예측 결과와 잘 일치하는 동시에 결합기로서의 특성도 우수함을 보여 준다.This paper describes the design of a size-reduced branch line coupler using stripline transmission line structure and common defected ground structure (CDGS) with the fabrication and measurement results. The stripline branch line coupler is designed because there are advantages of stripline with low loss and excellent transmission characteristics comparing them to those of microstrip lines. Furthermore, combining CDGS which is one of periodic structures with into the common ground plane of the multi-layered stripline structure, and folding the circuit, then the size becomes almost half from the previous design. The measurement shows that the port matching is better than –25 dB, the isolation is less than –30 dB, and the power division ratio to the two output ports are –3.3 dB at the design frequency. These excellent measured data are in good agreement with the prediction even after the circuit has been reduced by almost half-size.