재료의 손상 상태나 미시적 특성을 나타내는 정량적인 지표로서 비선형 파라미터 가 자주 사용되고 있다. 원칙적으로 값은 1차원 평면파가 비선형 매질을 전파할 때 발생하는 기본파 변위와 제2차 고조파 변위를 측정함으로써 구할 수 있다. 하지만 실제 실험에서는 파동의 전파 및 수신 과정에서 빔의 회절과 감쇠 현상이 수반된다. 최근까지의 연구 결과를 보면 회절 효과를 무시하기 위해 대부분 근거리 음장 내에서 가 측정되었다. 회절 효과를 무시하기 위해서는 탐촉자의 형상, 입력 주파수, 시편의 두께 등에 대한 제한이 따른다. 이러한 제한이 없는 실용적인 측정 기술에 대한 연구가 필요하다. 이에 본 논문에서는 두께 4cm ~ 12cm의 알루미늄 시편에 대하여 유한진폭법으로 를 측정하고, 회절 및 감쇠 효과가 측정값에 미치는 영향을 체계적으로 연구하였다. 정확한 측정을 위해서는 회절 및 감쇠에 대한 올바른 보정이 모두 필요함을 확인하였고, 이 경우 전 시편에 걸쳐 약 4% 이내로 일치하는 값을 얻을 수 있었다.The nonlinearity parameter is commonly used as an important indicator of damage state and microstructural characteristics. This parameter can be obtained by measuring the fundamental and second harmonic wave displacements when a one-dimensional plane wave propagates in the nonlinear medium. However, in a real experimental situation, beam diffraction and medium attenuation always appear during propagation and reception. Most of the previous studies ignored these effects by restricting the measurements in the near field. In the present study, 4-to 12-cm-thick solid samples were prepared, and measurements were made using the finite amplitude method. The effects of diffraction and attenuation corrections on the values were then systematically investigated. The agreement of between different-thickness samples when diffraction and attenuation corrections were all properly made was better than 4%.