비선형 파라미터 β 측정은 대부분 투과법이 사용되고 있다. 투과법 β 측정에 기초한 손상탐지는 사용 중 재료에 대한 현장 적용을 어렵게 하며, 현재 매우 제한적으로 사용되고 있는 실정이다. 따라서 현장 적용성을 높이기 위한 β 측정 기술의 개발이 필요하며, 시편의 한 면을 사용하는 펄스-에코법은 이러한 목적을 달성하는데 가장 적합한 방법으로 고려될 수 있다. 하지만, 단일 요소 탐촉자를 이용해 펄스-에코로 비선형 파라미터를 측정하기에는 많은 제약으로 사용될 수 없었다. 이에 본 연구에서는 송신부와 수신부가 분리된 형태의 이중 요소 탐촉자를 제작하였다. 이중 요소 탐촉자를 이용해 시편의 한 면을 사용하는 반사 모드에서 비선형 파라미터 측정에 대한 연구를 수행하였다. 비선형 파라미터 측정은 비선형 특성이 잘 알려진 3가지 종류의 알루미늄 시편에 대해서 반사모드와 기존의 투과법으로 진행하였다. 두 가지 방법으로 측정된 비선형 파라미터 β는 오차 10%로 이내로 일치하였다. 반사 모드에서 비선형 파라미터 측정의 가능성과 타당성을 확인하였다.For the purpose of early damage detection, the transmission method is mainly used for nonlinear parameter (β) measurements. Transmission measurements make it difficult to apply nonlinear acoustic methods to real tests and are currently used limitedly. Therefore, the pulse-echo method can be considered the most suitable measurement technique for improving field applications. However, due to many constraints, it was not possible to measure β with the pulse-echo method using a single element transducer. In this study, we developed a dual element transducer in which the transmitter and receiver are separated. The dual element transducer was applied to reflection mode β measurements using one side of specimens. The β was measured for three types of aluminum specimens, and the results were compared with those of the transmission method. The β measured using the two methods were within 10% difference, validating β measurements in the reflection mode using the dual element transducer.